Detail One

Directions for Use – Detail One Quick Detail Spray

1. Shake well before use to ensure optimal results.
2. Spray a light, even mist of Detail One onto the desired surface.
3. Using a clean, microfiber towel, gently buff the surface in circular motions.
4. Flip the towel to a clean, dry side and continue buffing until the surface achieves a high-gloss finish.
5. For heavily soiled areas, repeat the process or use a soft cloth to wipe away dirt before applying Detail One.

Tip: For best results, apply in small sections, working one panel at a time. Always use on a cool surface, avoiding direct sunlight.

Enhance Application Directions (Version 1)

1. Clean panels with any panel prep solution edge to edge.
2. Wipe down panels with medium urethane reducer edge to edge and make sure to apply pressure in scratched areas.
3. Apply Enhance using a microfiber applicator pad to the panels in a crosshatch method over the entire vehicle.
4. Allow Enhance to dwell on the panels for 5–10 minutes.
5. Lightly level the first panel coated with the short pile side of a microfiber towel in circular motions across the entire panel.
6. Flip the microfiber towel over to the high pile side and lightly level the panel left to right until a high gloss finish is achieved.
7. Follow steps 5 and 6 on every panel coated.

Enhance Application Directions (Version 2)

1. Clean panels with any panel prep solution edge to edge.
2. Wipe down panels with medium urethane reducer edge to edge and make sure to apply pressure in scratched areas.
3. Apply Enhance using a microfiber applicator pad to the panels in a crosshatch method over the entire vehicle.
4. Allow Enhance to dwell on the panels for 5–10 minutes.
5. Lightly mist one panel at a time with Atomic starting with the first panel coated.
6. Lightly level the panel with the short pile side of a microfiber towel in circular motions across the entire panel.
7. Flip the microfiber towel over to the high pile side and lightly level the panel left to right until a high gloss finish is achieved.
8. Follow steps 6 and 7 on every panel coated.

Depth - Trim Application Directions

1. Clean Trim with any dedicated wax and grease remover edge to edge.
2. Apply Depth on prepped trim pieces with an applicator sponge or a fine microfiber pad.
3. If the trim looks to be more saturated in specific areas than others, wipe excess with a microfiber towel.

Clarity - Headlight Restoration Directions

1. Mask off surfaces surrounding the headlight lens.
2. Wet sand with 600 grit. (More abrasive grits may be needed depending on the severity of damages. Example: 320 or 400 grit. Always finish with 600 grit.)
3. Once you can see a uniform haze across the entire headlight lens, rinse the headlight lens from left to right, top to bottom to remove all the excess residue from wet sanding.
4. Clean up surrounding workspace areas and remove masking material.
5. Take a lint free towel and dry the headlight off, making sure to remove any moisture that can be trapped around the headlight lens.
6. Thoroughly clean the headlight lens with a lint free towel and isopropyl alcohol.
7. Mask off surfaces surrounding the headlight lens to avoid any overspray.
8. Shake Clarity for 30 seconds.
9. Hold Clarity upright, approximately 3 to 4 inches from the headlight lens surface and apply one even coat.
10. Allow the headlight lens to cure in direct sunlight for a minimum of 15 minutes. For a more complete cure, allow a minimum of 45 minutes of direct sunlight exposure.